Toro Groundsmaster 4000-D Service Manual page 295

Removal
1. Park machine on a level surface, lower cutting
decks, stop engine, apply parking brake and remove
key from the ignition switch.
2. Remove hood using Figure 23 as a guide.
Installation
1. Install hood using Figure 23 as a guide.
2. Align hood to machine to allow correct operation of
hood latch and dust seals:
A. Place shim that is from 3/8" to 7/16" (9.5 to 11.1
mm) thick on top of frame (both RH and LH sides)
near the sides of oil cooler (Figs. 24 and 25).
B. Close hood so that it rests on shims and fasten
the hood latches.
C. Loosen hood pivots at frame to adjust vertical
placement of pivots. Re--tighten hood pivot fasten-
ers.
D. Loosen screen pivots to allow hood latches to pull
hood against radiator support. Re--tighten screen pi-
vot fasteners.
3. After hood is assembled to machine, check for the
following:
A. Check that bulb and foam seals are equally com-
pressed at all contact points with hood.
B. Hood should open and close without contacting
oil cooler hardware.
Groundsmaster 4000--D/4010--D
1
1. LH shim location
2. LH hood pivot
3
2
1. RH shim location
2. RH hood pivot
Page 7 - - 23
3
2
Figure 24
3. LH screen pivot
Figure 25
3. RH screen pivot
Chassis
1