Heater/Evaporator Assembly
10
10
1
5
1. Heater/evaporator assembly
2. Top cover
3. Flange head screw (2 used)
4. Drier- -receiver mount
Removal (Fig. 7)
1. Park machine on a level surface, lower cutting
decks, stop engine, engage parking brake and remove
key from the ignition switch.
2. Remove fasteners that secure roof in place. Raise
and support roof to allow access to heater/evaporator
assembly (see Roof Assembly Removal in this section).
Operator Cab
8
11
5. Bottom cover
6. Hose clamp (2 used)
7. Speed nut (8 used)
8. Panel nut (4 used)
10
4
7
Figure 7
3. Disconnect wire harness connectors from fan motor
and binary switch on drier--receiver.
4. Read the General Precautions for Removing and
Installing Air Conditioning System Components at the
beginning of the Service and Repairs section of this
chapter.
Page 9 - - 10
2
10
3
9
6
8
11
9. Drier- -receiver assembly
10. Screw (8 used)
11. Screw (5 used)
Groundsmaster 4010--D