Table of Contents
Advertisement
Motor Control I/O Board User's Manual
4. Click File and select Open Workspace.
5. Browse to C:\NECTools32\ \Motor_Control\BLDC_Hall_714 and select BLDC_LV.prw PM
Plus workspace file.
6. The newly loaded workspace file will contain one project called LV_BLDC_Hall-714.prj as
shown below.
7. To recompile the code, click Build and select Rebuild.
8. At this point, you may change the code and recompile as needed.
9. After building the code successfully, you may download and run or debug the code using an on-
chip debugging emulator.
9. Download and Debug the Code
1. To debug the code, select Debug from Build menu or click the Debug button on the tool bar. By
default the code automatically will be downloaded to the microcontroller's flash memory
10
Figure 12. PM Plus Workspace
Figure 13. PM Plus Window
Advertisement
Table of Contents
