Table of Contents
Advertisement
Motor Control I/O Board User's Manual
Figure 3. Motor Phase Connections
Figure 4. Hall Sensor Connections
The software to run the motor is programmed into the microcontroller's flash memory. After the
motor is connected, the program is ready to run the motor as soon as the 15V
power supply is
DC
plugged into J6 of the MC-IO board and power switch SW1 on the MC-PWR-LV power module is
turned ON.
When the kit is powered up or reset, the LED displays "SELF", indicating that the kit is in
standalone mode and you can use the pushbuttons and potentiometer on the MC-IO board to control
the motor.
3
Advertisement
Table of Contents
