Motor Control I/O Board User's Manual
For the instruction descriptions, refer to the 78K/0 Series Instruction User's Manual (U12326E)
3. Hardware Setup
The kit can be purchased as one unit with all three boards connected as shown below:
To attach the motor, connect the phase U, V and W terminals to the J3 connector block on the MC-
PWR-LV power board and the Hall sensor terminals to the J5 connector block on the MC-IO control
board.
Table 1.
Motor Connections
Pittman N2311 Motor Terminals
Phase U
- Beige
Phase V
- Red
Phase W
- Orange
Hall sensor 1
- Gray
Hall sensor 2
- Blue
Hall sensor 3
- White
Hall sensor 5V
- Purple
DC
Hall sensor GND - Black
Motor terminal connections are shown in Figures 3 and 4.
2
Figure 2. MC-LV-KIT-714 Boards Stacked Up
MC-IO
—
—
—
J5–13
J5–14
J5–7
J5–6
J5–5
MV-PWR-LV
J3 - 1
J3 - 2
J3 - 3
—
—
—
—
—