Turning Off The Projector; After Use - NEC LT265 User Manual

Turning off the Projector

To turn off the projector:
1. Press the POWER (ON/STAND BY) button on the projector
cabinet or the POWER OFF button on the remote control.
The "Power Off / Are you sure?" message will appear.
2. Press the ENTER button or the POWER (ON/STANDBY) or
the POWER OFF button again.
The power indicator will glow orange. After the projector turns
off, the cooling fans keep operating for 90 seconds (Cooling-off
time).
NOTE: Immediately after turning on the projector and displaying an
image, you cannot turn off the projector for 60 seconds.
3. Turn off the Main Power switch. The power indicator will go
out.
CAUTION
Do not unplug the power cable from the wall outlet or do
not turn off the main power under any one of the following
circumstances.
Doing so can cause damage to the projector or PC card:
• While the projector lamp is lighted.
• While the cooling fans are running. (The cooling fans
continue to work for 90 seconds after the projector is turned
off).
• While the PC CARD Access Indicator lights. Doing so can
damage your PC memory card.

After Use

Preparation: Make sure that the main power is turned off.
1. Unplug the power cable.
2. Disconnect any other cables.
3. Retract adjustable tilt feet if extended.
4. Cover the lens with the lens cap.
5. Put the projector and its accessories in the supplied soft case.
NOTE: Before putting the projector in the soft case, be sure to retract the feet. Failure to do so may cause the damage to the
projector.
3. Projecting an Image (Basic Operation)
SELECT
PC CARD
SELECT
PC CARD
37
OFF
MAGNIFY
SOURCE AUTO ADJUST
LAMP
STATUS
3D REFORM ON/STAND BY POWER
OFF
MAGNIFY
SOURCE AUTO ADJUST
LAMP
STATUS
3D REFORM ON/STAND BY POWER
ON
POWER
LASER
PAGE
UP
POINTER
DOWN
ON
POWER
LASER
PAGE
UP
POINTER
DOWN