Complete The Network Connections To The Hub; Connecting Devices To The Hub - HP AdvanceStack J2610B Installation And Reference Manual

4. Complete the network connections
to the hub
Reconnect the hub to the power source and then make the network
connections to the hub. Typical hub connections are:
Hub-to-device connections. Connecting to network devices such
as computers and printers.
Hub-to-hub connections. Connecting to another HP AdvanceStack
Hub or other Ethernet hub.
Hub-to-network backbones. Connecting to a network backbone.
This section describes the different ways you can connect your hub to your
network.

Connecting Devices to the Hub

To connect a device to the hub, push the RJ-45 plug into the RJ-45 jack until
the tab on the plug clicks into place.
RJ-45 plug
unshielded twisted-pair cable
to a computer or printer
Installing the Hub
1-9