Fujitsu control 4 0812 User Manual page 58

4. Video Viewer
After the interactive session is closed, the thumbnail is included in the scan
sequence again.
You can disable a target device thumbnail from the scan sequence. The
thumbnail image remains, but it is not updated until it is once again enabled.
Accessing scan mode
To access scan mode:
1. Select the Appliance, Devices, Sites, or Folders button in the Explorer
window.
2. Select two or more target devices in the Unit list by pressing the Shift or
Control key. The Scan Mode button is visible.
3. Click the Scan Mode button. The Thumbnail Viewer window opens.
Setting scan options
To set scan preferences:
1. Select Options-Preferences from the Thumbnail Viewer menu. The
Preferences window opens.
2. In the View Time Per Server field, enter the time each thumbnail is active
during the scan, in the range of 10 to 60 seconds.
3. In the Time Between Servers field, enter the time the scan stops between
each target device, in the range of 5 to 60 seconds.
4. Click OK.
To change the thumbnail size, complete the following steps:
1. Select Options-Thumbnail Size from the Thumbnail Viewer menu.
2. Select a thumbnail size from the cascaded menu.
Managing the scan sequence
To pause or restart a scan sequence:
1. Select Options-Pause Scan from the Thumbnail Viewer menu.
2. The scan sequence pauses at the current thumbnail if the Thumbnail Viewer
has a scan in progress or restarts the scan if currently paused.
To disable a target device thumbnail in the scan sequence:
• Select a target device thumbnail. Select Thumbnail-<target device name>-
Enable from the Thumbnail Viewer menu. (The Enable menu item state can
52
590-1059-640A