Panasonic AG-CPD20P Operating Instructions Manual page 14

Control Reference Guide
Rear panel (2)
AUDIO IN 1 (black), 2 (red),
3 (black), and 4 (black)
connectors (Pin jack)
These are line or microphone level
signal inputs.
The output signals of audio
components or wireless microphones
can be connected here.
SERIAL connector
For RS-232C. Connect a
commercially available radar gun.
GPIO connector
This combo connector accepts
up to 16 trigger signal (GPI1-16)
inputs and supplies up to four signal
(GPO1-4) outputs. Connect the
trigger cable here (included in the
separately sold Cable Kit).
USB connector
Connect a specified, commercially
available wireless LAN module. (For
a specified, commercially available
wireless LAN module, consult your
supplier.)
14
(continued)
DC IN connector
(
This connector accepts power from
the vehicle battery.
Connect the power cable here
(included in the separately sold
Cable Kit).
Note:
Do not pull out the power cable
(included in the separately sold
Cable Kit) while the recorder is
running. Turning the power off
especially during access (for
example, during recording) may
damage the SDHC Memory Card
or corrupt file management data,
setting information and other data on
the SDHC Memory Card.
Cable Clamp
Use this clamp to affix video, audio,
camera cables and the power cable
(included in the separately sold
Cable Kit).
)