Indicator Lamp In Charging Station - Husqvarna 420 Operator's Manual

Message
Difficult finding home
Temporary problem
with the server.
Connection problems
Connection settings
restored
Weak signal
SIM card requires PIN
SIM card locked
SIM card not found
Geofence problem
SMS could not be sent

9.3 Indicator Lamp in Charging Station

For a fully functional installation, the indicator lamp in the charging station must emit a solid green light. If something
else appears, follow the troubleshooting guide below.
There is more troubleshooting help on www.automower.com. If you still need help with troubleshooting, please contact
the local dealer.
Light
Solid green light
Green flashing light
Blue flashing light
Red flashing light
English - 84
1157866-26,420,430X,450X,EN_160314.indd 84
TROUBLE SHOOTING
Cause
The robotic lawnmower has followed
the boundary wire several time without
finding the charging station.
Please try again.
Problem with the Automower®
Connect module
Settings for wireless connectivity have
been restored due to an error.
Weak GPRS signal for Automower®
Connect module
The SIM card must be unlocked.
The SIM card must be replaced.
Automower® Connect requires a SIM
card to be inserted in the mower.
Your Geofence is not working due to
poor (or no) communication with GPS
system.
Poor GSM coverage
Max. number of SMS reached, max.
10 SMS per month can be sent to the
mower.
No funds left on SIM card.
Cause
Good signals
The signals are good and ECO mode
is activated.
The boundary loop is not connected
to the charging station
Break in the boundary loop
Interruption in the charging station's
antenna
Action
Installation has not been completed correctly.
Incorrect setting of corridor width on boundary wire.
The lawn mower was started on a secondary area
with a main area setting.
In case of persisting problems, get in touch with
your local dealer.
Restart the mower. If the fault persists, action by
and authorized service technician will be required.
Check and revise settings if necessary.
Make sure the mower is not upside down. If the
problem persists, action by and authorized service
technician will be required.
Make sure the correct SIM PIN has been entered
into the mower's menu (Network > SIM card). In
case of persisting problems, get in touch with your
local dealer.
Contact the local dealer.
Contact your local dealer for more information.
Contact the local dealer.
In case of persisting problems, get in touch with
your local dealer.
Action
No action required
No action required. For more information on ECO
mode, see 6.9 Settings on page 61.
Check that the boundary wire connector is fitted
properly to the charging station. Refer to 3.5
Connecting the Boundary Wire page 27.
Find out where the break is. Replace the
damaged section of the loop with a new loop wire
and splice using an original coupler.
Contact the local dealer.
2016-03-14 17:00:04