Hitachi DV 14DSDL Service Manual page 5

(3) When mounting the DC-Speed Control Switch [50] in housing (A), fit the protrusion of the
forward/reverse changeover lever on top of the DC-Speed Control Switch [50] into the hole groove of
the Pushing Button [48].
(4) Pass the internal wire connected to the LED light between the housing ribs as shown in Fig. 3.
(5) Pass the internal wire connected to the DC-Speed Control Switch [50] between the ribs as shown in
Fig. 3.
(6) Bend the internal wire under the Controller Terminal Set [46] so that it fits in the housing. However, be
careful not to break the internal wire when bending. Do not bend the internal wire toward the noise
suppressor. If the internal wire contacts the noise suppressor, malfunction may be caused (Fig. 3).
NOTE: The contact between the terminal support and battery may be hot when covered with
black metal oxides or when its plating is separated. In extreme cases, the battery and
product may be damaged. Replace the Controller Terminal Set [46] with a new one.
Fig. 3
Pass the internal wire
(brown) between the
housing and the Controller
Terminal Set [46].
Internal wire (white)
Internal wire (black)
Internal wire (brown)
Terminal support LD terminal
Terminal support (+) terminal
-4-
Pass the internal wire
between the housing ribs.
Controller Terminal Set [46]
Terminal support
Terminal support (-) terminal
Do not bend the internal wire
toward the noise suppressor.