Toro 03540 Reelmaster 5200-D Operator's Manual page 17

Figure 7
1. Carrier frame
4. Install a roll pin (Figure 8) into the hole in the
appropriate side of each cutting unit carrier
frame (Figure 6).
Figure 8
1. Carrier frame
2. Roll pin
5. Align the mounting shaft of the cutting unit
with the pivot tube on the carrier frame. Insert
the shaft into the tube (Figure 9).
2. Basket guide
3. Basket bracket
4. Basket collar
1. Cutting unit mounting
shaft
2. Carrier frame pivot tube
3. Thrust washer
6. Secure the shaft in the pivot tube with a thrust
washer, flat washer, lock washer, and bolt
(Figure 9).
7. Assemble the mounting nuts for the reel drive
motor to each cutting unit (Figure 10). Leave
approximately 1/2 inch (1.25 cm) of threads
exposed on each mounting stud.
Figure 10
1. Reel drive motor
8. Coat the spline shaft of the motor with clean
grease and install the motor by rotating it
clockwise so that the motor flanges clear the
studs. Rotate the motor counterclockwise until
the flanges encircle the studs and tighten the
17
Figure 9
4. Flat washer
5. Lock washer
6. Bolt
2. Mounting nuts