Sound Pressure Level; Sound Power Level; Vibration Level - Toro 03540 Reelmaster 5200-D Operator's Manual

– Do not drive close to sand traps, ditches,
creeks, or other hazards.
– Reduce speed when making sharp turns.
Avoid sudden stops and starts.
– When near or crossing roads, always yield
the right-of-way.
– Apply the service brakes when going
downhill to keep forward speed slow and
to maintain control of the machine.
• The grass baskets must be in place during
operation of the cylinders/reels or thatchers
for maximum safety. Shut the engine off
before emptying the baskets.
• Raise the cutting units when driving from one
work area to another.
• Do not touch the engine, silencer/muffler, or
exhaust pipe while the engine is running or
soon after it has stopped because these areas
could be hot enough to cause burns.
• Stay clear of the rotating screen at the side of
the engine to prevent direct contact with your
body or clothing.
• If the engine stalls or loses headway and cannot
make it to the top of a slope, do not turn the
machine around. Always back slowly, straight
down the slope.
• When a person or pet appears unexpectedly
in or near the mowing area, stop mowing.
Careless operation, combined with terrain
angles, ricochets, or improperly positioned
guards can lead to thrown object injuries. Do
not resume mowing until the area is cleared.
Maintenance and Storage
• Make sure all hydraulic line connectors are
tight and all hydraulic hoses and lines are in
good condition before applying pressure to the
system.
• Keep your body and hands away from pin hole
leaks or nozzles that eject hydraulic fluid under
high pressure. Use paper or cardboard, not
your hands, to search for leaks. Hydraulic fluid
escaping under pressure can have sufficient
force to penetrate the skin and cause serious
injury. Seek immediate medical attention if
fluid is injected into skin.
• Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved by stopping the engine
and lowering the cutting units and attachments
to the ground.
• Check all fuel lines for tightness and wear on a
regular basis. Tighten or repair them as needed.
• If the engine must be running to perform a
maintenance adjustment, keep hands, feet,
clothing, and any parts of the body away from
the cutting units, attachments, and any moving
parts, especially the screen at the side of the
engine. Keep everyone away.
• To ensure safety and accuracy, have an
Authorized Toro Distributor check the
maximum engine speed with a tachometer.
Maximum governed engine speed should be
2900 RPM.
• If major repairs are ever needed or if assistance
is desired, contact an Authorized Toro
Distributor.
• Use only Toro-approved attachments and
replacement parts. The warranty may be
voided if used with unapproved attachments.

Sound Pressure Level

This unit has an equivalent continuous A-weighted
sound pressure at the operator ear of: 88 dB(A),
based on measurements of identical machines per
EN 11094 and EN 836.

Sound Power Level

This unit has a guaranteed sound power level
of: 105 dBA/1 pW, based on measurements of
identical machines per EN 11094.

Vibration Level

This unit does not exceed a vibration level of 2.5
m/s 2 at the hands based on measurements of
identical machines per EN 1033.
This unit does not exceed a vibration level of 0.5
2
m/s at the posterior based on measurements of
identical machines per EN 1032.
7