Figure 32
Decal 98-9342
1. Reel—height of cut
2. Reel—mow and backlap
3. Read the Operator's
Manual.
4. To set the reel speed, rotate knobs (Figure 33)
until the indicator arrows are in line with the
number designating the desired setting.
4. Machine speed
5. Rear reels circuit controls
6. Front reels circuit controls
Figure 33
1. Reel speed control knobs
Note: The reel speed can be increased or
decreased to compensate for turf conditions.
Adjusting the Lift Arm Down
Pressure
You can adjust the down pressure spring on each
cutting unit lift arm to compensate for different
turf conditions. Increased down pressure will
help keep the cutting units on the ground when
mowing at higher speeds and helps maintain a
uniform height-of-cut in rough conditions or in
areas of thatch build up.
You can adjust each down pressure spring to one
of four settings. Each increment increases or
decreases down pressure on the cutting unit by 8
lb (3.6 kg).
1. Position the machine on a level surface, lower
the cutting units, stop the engine, engage the
parking brakes, and remove the key from
ignition switch.
2. Remove the floor plate in front of the seat and
open the hood to gain access to all 5 springs.
The springs are under tension.
Use caution when adjusting them.
3. Place an open end wrench on the hex shaft of
the spring bracket (Figure 34).
32