Kenwood DDX6034 Service Manual page 17

• DivX Registration Code
Display DivX Registration Code, and clear the Code with
[Clear] key.
After the clearing of the Code, display "None".
* Clear the Code after ejecting the Disc.
• DC Offset
When the DC Offset detection information is shown as
"None", it means that the offset is not detected. When it is
shown as "Detect (X)", it means that the offset is detected.
(X=1~3 : The number of capacitor leak detected)
Clear the detection information using the [Clear] key.
• Service Information
Power ON time, Disc play back time, Monitor Open count,
and Disc Eject count are displayed.
Press the [Init] key of an item to initialize to select it. (Multiple
selections are available / the selected items are focally dis-
played)
After selecting the item to initialize, pressing the [Start] key
for 1 second or more will initialize the selected service infor-
mation.
2.3.4. Serial No. Entry screen
Enter the serial number of each set from this screen.
The Serial No. Entry screen is shown in Figure 2.3.4.
Serial Number Input
– – – – – – – –
1 2 3
4 5 6
7 8 9
Clear 0 Cancel
Figure 2.3.4 Serial No. Entry screen
Key Specifi cation
0~9 : 10key used to enter the serial number.
Clear : Clear the serial number being input.
Cancel : Transfer to Service screen.
Enter : Start entering the serial number.
Return : Transfer to Service screen.
TEST MODE
Serial Number Input
X X X X X X X X
Clear Enter Cancel
Serial Number Input
Write OK/NG
Return
DDX6034/6034M/6054/7034BT/7034BTM/714
DNX7000EX/7140/7240BT/7340BT
* Select black for the background color until "Write OK/NG"
is displayed.
Modify the background color to blue at the same time as
"Write OK" is displayed.
Modify the background color to red at the same time as
"Write NG" is displayed.
* When "Write NG" is displayed after pressing the [Enter]
key, enter the Test mode again to start from the beginning.
2.3.5. Tuner Mute Level Adjustment screen
Perform adjustment of the Mute Level memorized in the
nonvolatile memory of Tuner F/E.
The Tuner Mute Level screen is shown in Figure 2.3.5.
Tuner Mute Level
DW UP
∗∗∗∗
Cancel
■Write
Figure 2.3.5 Tuner Mute Level Adjustment screen
Key Specifi cation
UP : Mute Level Up
DW : Mute Level Down
■Write : Press this key for 1 seconds or longer to make
the data writing into the nonvolatile memory.
Cancel : Transfer to Service screen.
Return : Transfer to Service screen.
* Select black for the background color until "Write OK/NG"
is displayed.
Modify the background color to blue at the same time as
"Write OK" is displayed.
Modify the background color to red at the same time as
"Write NG" is displayed.
* Adjust the Tuner Mute Level under the following condi-
tions. Under the other conditions than the followings, the
Tuner Mute Level can not be adjusted if the Tuner Mute
Level Setup screen is shown.
The frequency shall have to be set before transferring to
the Tuner Mute Level Adjustment screen. (Even after com-
pleting adjustment, the frequency remains the same.)
Audio Source : Tuner
LOUD : OFF
Volume : Step30
Frequency : Default value of the set
Tuner Mute Level
Write OK/NG
Return
17