Service Interval Chart
Premaintenance
Procedures
Removing the Seat
The seat may be removed to ease performing maintenance in
the valve block area of the machine.
1. Unlatch and raise the seat. Secure with prop rod.
2. Disconnect the 2 wire harness connectors under the
seat.
3. Lower the seat and remove the cotter pin securing the
seat pivot rod to the frame (Figure 33).
1. Cotter pin
4. Slide the seat pivot rod to the left side, slide the seat
forward, and lift the seat out.
5. Reverse the procedure to install the seat.
Figure 33
2. Seat pivot rod
Figure 32
Jacking the Machine
CAUTION
Before servicing, support the machine with jacks
stands or blocks of wood.
Before jacking the machine, lower the cutting units. The
jacking points are as follows:
•
Right side-under the jack pad and adjacent to the ROPS
(Roll Over Protection System) support bracket (Figure 34)
•
Left side-under the step
•
Rear-at the castor fork
1. Jack pad
30
Figure 34