Adjusting The Anti-Scalp Rollers - Toro 74906 Operator's Manual

position for the transport position of the mower deck
24).
1
2
3
Figure 24
Transport-Lock Positions
1. Transport lock
2. L position—The
OCK
mower deck locks into the
transport position.
(Figure
g032377
3. U position—The
NLOCK
mower deck does not lock
into the transport position.
Adjusting the Height-of-Cut Pin
The height of cut is adjusted from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by moving the
clevis pin into different hole locations.
1. Move the transport lock to the
2. Push on the deck lift pedal with your foot and raise the
mower deck to the transport position (also the 140 mm
(5-1/2 inch) cutting-height position); refer to
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket
4. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired, and insert the pin
25).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
1. Deck lift pedal
2. Height-of-cut pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, it is recommended to
adjust the height of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
23
position.
LOCK
(Figure 25).
Figure 25
3. Transport lock
-
NEUTRAL LOCK
Figure 25.
(Figure
position,