Replacing The Grass Deflector; Cleaning; Cleaning Under The Mower; Disposing Of Waste - Toro 74906 Operator's Manual

Replacing the Grass Deflector

WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects at you or bystanders,
resulting in serious injury. Also, contact with the
blade could occur.
Do not operate the lawn mower unless you install a
cover plate, mulch plate, grass deflector, or bagger.
1. Remove the locknut, bolt, spring, and spacer holding
the deflector to the pivot brackets
Remove the damaged or worn grass deflector.
6 2
1
g015594
Figure 106
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Place the spacer and the spring onto the grass deflector.
Place one J end of the spring behind the deck edge.
Note: Make sure that 1 J-end of the spring is installed
behind the deck edge before installing the bolt as
shown in Figure 106.
3. Install the bolt and the nut. Place one J-hook end of
the spring around the grass deflector
Important: The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the full
down position.
(Figure 106).
4
7
3
5
5. Spring installed
6. Grass deflector
7. J-hook end of spring
(Figure 106).

Cleaning

Cleaning under the Mower

Service Interval: Before each use or daily
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Raise the mower to the transport position.

Disposing of Waste

Engine oil, batteries, hydraulic oil, and engine coolant are
pollutants to the environment. Dispose of these according to
your state and local regulations.
64
- position
NEUTRAL LOCK