Servicing The Engine Oil - Toro 74906 Operator's Manual

2. If the inner filter is being replaced, carefully slide it into
the filter body (Figure
3. Carefully slide the primary filter over the inner filter
(Figure 47).
Note: Ensure that the primary filter is fully seated by
pushing on its outer rim while installing it.
Important: Do not press on the soft inside area
of the filter.
4. Install the air cleaner cover and secure the latches
(Figure 47).
47).

Servicing the Engine Oil

Oil Type: Detergent oil (API service class SL, SM, SN, or
higher)
Oil Capacity: with a filter change, 1.7 L (58 oz); with no
filter change, 1.4 L (47 oz)
Viscosity: See the table below.
0
0
Note: Use of synthetic oil having 5W-20 or 5W-30 rating is
acceptable, up to 4 degrees C (40 degrees F).
Note: Synthetic oils will provide better starting in extreme
cold below -23 degrees C (-10 degrees F).
Checking the Engine-Oil Level
Service Interval: Before each use or daily
Note: Check the oil when the engine is cold.
WARNING
Contact with hot surfaces may cause personal
injury.
Keep hands, feet, face, clothing and other body
parts away from the muffler and other hot surfaces.
Important: Do not overfill the crankcase with oil
because damage to the engine may result. Do not run
engine with oil below the low mark because the engine
may be damaged.
1. Disengage the PTO, move the motion-control levers to
the -
NEUTRAL LOCK
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position (Figure
35
SAE 30
50
Figure 48
position and set the parking brake.
49).
g012991