Toro 31202 Operator's Manual page 17

InfoCenter Icon Description (cont'd.)
InfoCenter
Bad or failed
Bulb
Output of TEC controller or control
wire in harness
Switch
Operator must release switch
Operator should change to indicated
state
Symbols are often
combined to form
sentences. Some
examples are shown
below
Operator should put machine in
neutral
Engine start denied
Engine shutdown
Engine coolant too hot
DPF ash accumulation notification.
Refer to Servicing the Diesel
Particulate Filter (DPF) in the
maintenance section for details.
Sit down or set parking brake
Using the Menus
To access the InfoCenter menu system, press the menu access
button while at the main screen. This will bring you to the
main menu. Refer to the following tables for a synopsis of
the options available from the menus:
Main Menu
Menu Item
Faults
Description
The Faults menu contains
a list of the recent machine
faults. Refer to the Service
Manual or your Authorized
Toro Distributor for more
information on the Faults
menu and the information
contained there.
Service
Diagnostics
Settings
About
Service
Menu Item
Hours
Counts
Diagnostics
Menu Item
PTO
Engine Run
Decks
Steer Mode
Machine Input
Settings
Menu Item
Units
Language
17
The Service menu contains
information on the machine
such as hours of use counters
and other similar numbers.
The Diagnostics menu
displays the state of each
machine switch, sensor and
control output. You can use
this to troubleshoot certain
issues as it will quickly tell you
which machine controls are on
and which are off.
The Settings menu allows
you to customize and modify
configuration variables on the
InfoCenter display.
The About menu lists the
model number, serial number,
and software version of your
machine.
Description
Lists the total number of hours
that the machine, engine and
PTO have been on, as well
as the number of hours the
machine has been transported
and service due.
Lists numerous counts the
machine has experienced.
Description
Indicates the inputs, qualifiers
and outputs for enabling the
PTO circuit.
Indicates the inputs, qualifiers
and outputs for starting the
engine.
Indicates the inputs, qualifiers
and outputs for lifting and
lowering the deck.
Indicates the inputs, qualifiers
and outputs for switching
between 2 wheel steer and 4
wheel steer.
Indicates the state of other
machine inputs such as
accessories and A/C clutch.
Description
Controls the units used on the
InfoCenter. The menu choices
are English or Metric
Controls the language used
on the InfoCenter*.