Product Overview; Controls - Toro 31202 Operator's Manual

Product Overview

Controls

Become familiar with all the controls before you start the
engine and operate the machine.
Traction Pedal
The traction pedal (Figure
operation. Press the top of the pedal to move forward and the
bottom to move rearward. Ground speed depends on how
far you press the pedal. For no load, maximum ground speed,
fully press the pedal while the throttle is in the Fast position.
To stop, reduce foot pressure on the traction pedal and allow
it to return to the center position.
1. Parking brake
2. Brake pedal
3. Tilt steering pedal
Mow Speed Limiter
The mow speed limiter lever
to limit the traction speed while operating.
Brake Pedal
The brake pedal is used in conjunction with the brake pedal
latch to engage and disengage the parking brake
stop the machine, release the traction pedal and allow it to
return to the center position. The brake can assist in stopping
in an emergency situation.
Parking Brake
To engage the parking brake, push down on the brake pedal
and press the top forward to latch
parking brake, press the brake pedal until the parking brake
latch retracts.
3) controls the forward and reverse
Figure 3
4. Traction pedal
5. Mow speed limiter
(Figure 3) can be flipped forward
(Figure
(Figure 3). To release the
Tilt Steering Pedal
To tilt the steering wheel towards you, press the foot pedal
down, and pull the steering tower toward you to the most
comfortable position and then release the pedal
Engine Speed Switch
The engine speed switch
the engine speed. By momentarily tapping the switch, the
engine speed can be increased or decreased in 100 rpm
increments. By holding the switch down the engine will
automatically move to High or Low idle, depending on which
end of the switch is depressed.
1
7 6
1. InfoCenter
2. Power take off (PTO)
Switch
3. Engine speed switch
4. Steering selector switch
InfoCenter
The InfoCenter LCD display shows information about your
machine such as the operating status, various diagnostics and
other information about the machine
Ignition Switch
The ignition switch has three positions: Off, On/Preheat,
and Start (Figure
Power Take Off (PTO) Switch
The power take off (PTO) switch starts and stops the mower
3) To
blades (Figure 4).
Steering Selector Switch
Press the steering selector switch to the rear to engage 4 wheel
steering and forward to return to 2 wheel steering
Power Point
The power point is a 12 volt power supply for electronic
devices (Figure 4).
13
(Figure 4) has two modes to change
2 3 4
5
Figure 4
5. Power point
6. Ignition switch
7. Deck lift switch
(Figure
4).
(Figure 3).
G026098
4).
(Figure 4).