Driving The Machine; Steering Selection - Toro 31202 Operator's Manual

1. InfoCenter
2. Power take off switch
(PTO)
5. Turn the ignition key clockwise to the Run position.
The InfoCenter glow plug icon will turn on for 6
seconds.
6. After the InfoCenter glow plug icon goes out, turn
the key to the Start position. When the engine starts
release the key.
Important: Use starting cycles of no more than
15 seconds per minute to avoid overheating the
starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been completely drained.
Important: When engine is started for the first
time, or after an engine oil change, or an overhaul
of the engine, transmission, or wheel motor,
operate the machine with the engine speed switch
in the Slow position in both the forward and
reverse directions for one to two minutes. Also
operate the lift switch and PTO switch to ensure
proper operation of all parts. Then shut the engine
off and check fluid levels, check for oil leaks, loose
parts, and any other noticeable malfunctions.
CAUTION
Shut the engine off and wait for all moving
parts to stop before checking for oil leaks,
loose parts, or other malfunctions.
Stopping the Engine
1. Disengage the PTO, make sure the traction pedal is in
the neutral position, set the parking brake, and move
the engine speed switch to the idle position.
2. Let the engine idle for 60 seconds.
3. Turn the ignition key to the Off position. Wait for
all moving parts to stop before leaving the operating
position.
Figure 11
3. Ignition switch
4. Engine speed switch
4. Remove the key before transporting or storing machine.
Important: Make sure to remove the key as the
fuel pump or accessories may run and cause the
battery to lose charge.
Children or bystanders may be injured if they
move or attempt to operate the tractor while
it is unattended.
g026090 Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.

Driving the Machine

The throttle control regulates the engine speed as measured
in rpm (revolutions per minute). Place the throttle control in
the Fast position for best performance. Always operate in the
Fast throttle position when mowing.

Steering Selection

For maximum trimming and minimum turf damage the
machine should always be operated in 4 wheel steering.
However, when it is desired to transport the machine on roads
or trails, the machine can be switched into 2 wheel steering.
1. Steering selector switch
Switching from 4 wheel steering to 2
wheel steering
Press the steering selector switch
position. If the wheels are not aligned in the forward position,
the green light will flash and the machine will remain in
4 wheel steering until the four tires are directed straight
ahead. The operator should turn the steering wheel slowly to
straighten out the wheels until the green light ceases to flash
and remains ON. When the switch light is solid green, the
machine is in 2 wheel steering.
Note: If the steering wheel is turned too briskly, steering
misalignment may occur.
22
CAUTION
Figure 12
(Figure
g026089
12) to the forward