Checking The Engine-Oil Level; Breaking In A New Machine; Using The Rollover Protection System (Rops) - Toro 74919TE Operator's Manual

With 132cm or 152cm turbo force side discharge mower
Hide thumbs Also See for 74919TE:
Table of Contents

Advertisement

Filling the Fuel Tank
1. Park the machine on level ground.
2. Shut the engine off and set the parking brake.
3. Clean around the fuel-tank cap and remove it. Add
regular unleaded gasoline to the fuel tank until the level
is 6 to 13 mm (1/4 to 1/2 inch) below the bottom
of the filler neck. This space in the tank allows the
gasoline to expand. Do not fill the fuel tank completely
full; refer to
(Figure

Checking the Engine-Oil Level

Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to
Engine-Oil Level (page
39).
7).
Figure 7
Checking the

Breaking in a New Machine

New engines take time to develop full power. Mower decks
and drive systems have a higher amount of friction when they
are new, placing additional load on the engine. Allow 40 to
50 hours of break-in time for new machines to develop full
power and best performance.
Using the Rollover Protection
System (ROPS)
WARNING
To avoid injury or death from rollover: keep the roll
bar in the fully raised locked position and use the
seat belt.
G009189
Ensure that the seat is secured to the machine.
WARNING
There is no rollover protection when the roll bar is
in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is
in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance permits.
• Check carefully for overhead clearances (i.e.
branches, doorways, electrical wires) before
driving under any objects and do not contact
them.
Important: Lower the roll bar only when absolutely
necessary.
Important: Ensure that the seat is secured to the
machine.
1. To lower the roll bar, apply forward pressure to the
upper part of the roll bar.
2. Pull both knobs out and rotate them 90° so they are
not engaged
3. Lower the roll bar to the down position
18
(Figure
8).
(Figure
8).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z master professional 6000 series74925te

Table of Contents