Mower Deck Maintenance; Leveling The Mower Deck - Toro 74919TE Operator's Manual

Figure 86
Bottom view of machine
1. Filter locations
6. Apply a thin coat of hydraulic oil to the rubber gasket
on the replacement filter
7. Install the replacement hydraulic filter.
8. Install the pump drive belt and the mower belt.
9. Remove the jack stands and lower the machine
85).
10. Add oil to the hydraulic reservoir and check for any
leaks.
11. Clean up any spilled oil.
12. Start the engine and let it run for about 2 minutes to
purge air from the system.
13. Stop the engine and check for leaks.
14. Check the oil level while the oil is cold.
15. If required, add oil to the hydraulic reservoir.
Note: Do not overfill the reservoir.
1
2
G008968
2. Hydraulic filter
(Figure 86).
(Figure
Mower Deck
Maintenance

Leveling the Mower Deck

Setting up the Machine
Note: Ensure the mower deck is leveled before matching the
height of cut (HOC).
1. Position mower on a flat surface.
2. Disengage the blade-control switch (PTO), move the
motion-control levers to the neutral-locked position,
and set the parking brake.
3. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
4. Check tire pressure of the drive tires. If needed, adjust
it to 90 kPa (13 psi).
5. Position the mower to the 76 mm (3 inch) height-of-cut
position.
Deck Leveling
1. Position the mower on a flat surface.
2. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
3. Check the tire pressure in the drive tires. Proper
inflation pressure for tires is 90 kPa (13 psi). Adjust it
if necessary.
4. Position the transport lock in to the latching position.
5. Push the deck-lift pedal all the way forward and the
deck will latch at the 14 cm (5-1/2 inch) transport
position (Figure
57
87).