Servicing The Fuses - Toro 74919TE Operator's Manual

4. Secure the cables with 2 bolts, 2 washers, and 2 locknuts
(Figure 62).
5. Slide the red terminal boot onto the positive (red)
battery post.
6. Install the clamp and secure it with the wing nut
62).
Charging the Battery
WARNING
Charging the battery produces gases that can
explode.
Never smoke near the battery and keep sparks and
flames away from the battery.
Important: Always keep the battery fully charged
(1.265 specific gravity). This is especially important to
prevent battery damage when the temperature is below
0°C (32°F).
1. Charge battery for 10 to 15 minutes at 25 to 30 amps
or 30 minutes at 10 amps.
2. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts
3. Install the battery in the machine and connect the
battery cables, refer to
Note: Do not run the machine with the battery
disconnected, electrical damage may occur.
1. Positive battery post
2. Negative battery post
(Figure 63).
Installing the Battery (page
Figure 63
3. Red (+) charger lead
4. Black (-) charger lead

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
(Figure
1. The fuses are located on right hand console next to
the seat
2. To replace the fuses, pull out on the fuse to remove it.
3. Install a new fuse
1. Optional
accessory—15 amp
44).
2. Charge—25amp
3. PTO—10amp
45
(Figure 64).
(Figure 64).
Figure 64
4. Main—25amp
5. Console