Table of Contents
Advertisement
Lubrication
Greasing the Bearings and
Bushings
Service Interval: Before each use or daily
Every 50 hours
The machine has grease fittings that you must lubricate
regularly with No. 2 lithium grease. Also, lubricate the
machine immediately after every washing.
Note: Bearing life can be negatively affected by improper
washing procedures. Do not wash the machine when it is still
hot, and avoid directing high-pressure or high-volume spray
at the bearings or seals.
1. Wipe the grease fittings clean so that foreign matter is
not forced into the bearing or bushing.
2. Pump grease into the fittings.
3. Wipe off any excess grease.
Note: To access the grease fittings of the rear steering
linkage, remove the storage compartment.
Note: Jack the machine off the floor to allow better
grease migration through both the upper and lower kingpin
bushings. Grease must be observed purging out of both the
top and the bottom of the axle casting/bushing assembly
areas of all 4 kingpin assemblies.
Figure 24
Engine Maintenance
Servicing the Air Cleaner
Service Interval: Before each use or daily—Check the
Every 400 hours—Service the air cleaner (earlier if the
air cleaner indicator shows red, and more frequently in
extremely dirty or dusty conditions).
Check the air-cleaner body for damage, which could cause an
air leak. Replace it if it is damaged. Check the whole intake
system for leaks, damage, or loose hose clamps.
30
G026734
air-cleaner indicator
Advertisement
Table of Contents
