Table of Contents
Advertisement
Stopping the Engine
1. Disengage the PTO, make sure that the traction pedal
is in the N
EUTRAL
move the engine speed switch to the idle position.
2. Let the engine idle for 60 seconds.
3. Turn the ignition key to the
4. Remove the key before transporting or storing machine.
Important: Remove the key; otherwise, the fuel
pump or accessories may run and cause the
battery to lose charge.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.
Driving the Machine
The throttle control regulates the engine speed as measured
in rpm (revolutions per minute). Place the throttle control in
the Fast position for best performance. Always operate in the
Fast throttle position when mowing.
Stopping the Machine
To stop the machine, release the traction pedal to the
N
position.
EUTRAL
Set the parking brake whenever you leave the machine.
Remember to remove the key from the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Operating the Mower
Raising and Lowering the Mower
The deck lift switch raises and lowers the mower deck
18). The engine must be running for you to use this switch.
position, set the parking brake, and
position.
OFF
1. Deck lift switch
•
To lower the mower deck, push the switch forward.
•
To raise the mover deck, push the switch rearward.
Important: Do not continue to hold the switch back
after the mower has fully raised. Doing so will damage
the hydraulic system.
Note: To lock the mower deck in a raised position, raise
the deck past the 15 cm (6 inch) position, remove the height
of cut stop pin, and place the pin in the 15 cm (6 inch)
height-of-cut position.
Engaging the Power Takeoff (PTO)
The power-takeoff (PTO) switch starts and stops the mower
blades and some powered attachments.
1. If the engine is cold, allow the engine to warm up 5 to
10 minutes before engaging the PTO.
2. While seated in the seat, make sure that the traction
pedal is in the Neutral position and the engine is at full
throttle.
3. Pull up on the PTO switch to engage it
1. PTO switch
(Figure
Disengaging the PTO
To disengage the PTO, push the switch to the
23
g026088
Figure 18
(Figure
g026087
Figure 19
position.
OFF
19).
Advertisement
Table of Contents
