Check Spark Arrester (If Equipped); Fuel System Maintenance; Servicing The Electronic Fuel Injection System; Replacing The Fuel Filter - Toro 74310 Operator's Manual

Check Spark Arrester (if
equipped)
Service Interval: Every 50 hours
WARNING
Hot exhaust system components may ignite
gasoline vapors even after the engine is stopped.
Hot particles exhausted during engine operation
may ignite flammable materials. Fire may result in
personal injury or property damage.
Do not fuel or run the engine unless spark arrester
is installed.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Wait for muffler to cool.
3. If any breaks in the screen or welds are observed,
replace the arrester.
4. If plugging of the screen is observed, remove the
arrester and shake loose particles out of the arrester
and clean screen with a wire brush (soak in solvent if
necessary). Reinstall arrester on exhaust outlet.
Fuel System
Maintenance
WARNING
Fuel system components are under high pressure.
The use of improper components can result in
system failure, gasoline leakage, and possible
explosion.
Use only approved fuel lines and fuel filters.
Servicing the Electronic Fuel
Injection System
This machine contains an electronic fuel injection system. It
controls the fuel flow under different operating conditions.
The electronic control unit (ECU) continuously monitors the
operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction indicator light (MIL) is illuminated. The MIL is
the red light located in the right console panel.
Once the MIL illuminates, initial trouble shooting
checks should be made. Refer to the MIL section under
Troubleshooting.
If these checks do not correct the problem, further diagnosis
and servicing by an Authorized Service Dealer is necessary.

Replacing the Fuel Filter

Service Interval: Every 200 hours/Yearly (whichever comes
first) (more often in dirty or dusty
conditions).
The fuel filter is located near the engine on the front or rear
side of the engine.
1. Move the speed control lever to the neutral position
to stop the machine.
2. Disengage the PTO, engage the parking brake, stop the
engine, and wait for all moving parts to stop.
3. Allow the machine to cool down.
4. Close the fuel-shutoff valve under the seat (Figure 39).
34