Toro 04060 Operator's Manual page 20

Maintenance
Lubrication
The (12) grease fittings on the mower should be
greased at least every 25 hours. Lubricate using No.
2 multi-purpose lithium base grease. A hand operat-
ed grease gun is recommended for best results.
1. Wipe each grease fitting with a clean rag.
2. The grease fitting locations are: (2) on The
front Roller (Fig. 17 ), (2) on the reel bearings
(Fig. 17), (2) on Drum Axles (Fig. 18), (3) on
Differential (Fig. 18), (2) on The reel
Countershaft Bearings (Fig. 19) and (1) on Belt
Idler Pivot (Fig. 20).
IMPORTANT: Do not apply too much pres-
sure or the grease seals will become perma-
nently damaged.
3. Wipe off excess grease.
Figure 17
Figure 18
20
Figure 19
Figure 20
Adjusting the Traction Drive Belt
1. Check tension by depressing the belt at its mid
span with 4±1 lbs. of force. The belt should
deflect 1/4 inch. If the deflection is incorrect,
go to the next step.
1
Figure 21
1. Traction drive belt
2. Idler pulley
2. To adjust belt tension:
2