Controls - Toro 04060 Operator's Manual

Controls

Traction Engagement Lever (Fig. 13)—Located on
the front right side of the control panel. The lever
has two positions: NEUTRAL and FORWARD.
Pushing the lever forward engages the traction drive.
Operator Presence Control (Optional) (Fig. 13)—
Located on the rear of the handle. Push the control
lever forward to engage. The lever must be engaged
before engaging the traction engagement lever or the
engine will stop.
Service/Park Brake (Fig. 13)—Located on the left
front side of control panel. Use the brake to slow or
stop the machine. The brake can also be used as a
parking brake. Pulling the lever back over the center
will set the parking brake.
Throttle Control (Fig. 13)—Located on the rear
right side of control panel. Control has two posi-
tions: SLOW and FAST. Engine speed can be varied
between the two settings.
2
1. Throttle control
2. Traction engagement pedal
3. Service/park brake
4. Operator presence control (optional)
Reel Drive Engagement Lever (Fig. 14)—Located
on the right front corner of the machine. The lever
has two positions: ENGAGE and DISENGAGE. Pull
up on the lever to engage the reel or push down on
the lever to disengage the reel.
Choke Lever (Fig. 15)—Located on the left front of
the engine. The lever has two positions: RUN and
CHOKE. Move the lever to CHOKE when starting
a cold engine. After the engine starts, move the
lever to RUN.
1
Fig. 13
1
1. Reel drive engagement lever
Fuel Shut-off Valve (Fig. 15)—Located on the left
front of the engine. The valve has two positions:
CLOSED and OPEN. Move the lever to CLOSED
when storing or transporting the machine. Move the
valve to OPEN before starting the engine.
4
3
1. Choke lever
2. Fuel shut off valve
Recoil Starter (Fig. 16)—Pull the recoil starter han-
dle to start the engine.
On/Off Switch (Fig. 16)—Located on the rear of the
engine. Move the switch to the ON position to start
the engine and to the OFF position to stop the
engine.
Kick Stand (Fig. 16)—Located at the rear of the
machine, the kickstand is used to raise the rear of the
machine for installation or removal of transport
wheels.
Fig. 14
1
2
Fig. 15
15