Preparing The Machine For Maintenance; Removing The Hood; Lubrication; Greasing The Bearings And Bushings - Toro 30604 Operator's Manual

•
Use jack stands to support the machine and/or its
components when required.
•
Carefully release pressure from components with stored
energy.
•
If your machine requires major repairs or if you desire
assistance, contact an Authorized Toro Distributor.
•
Use only genuine Toro replacement parts and accessories.
Replacement parts and accessories made by other
manufacturers could be dangerous, and such use could
void the product warranty.
Preparing the Machine for
Maintenance
1. Ensure that the PTO is disengaged.
2. Park the machine on a level surface.
3. Set the parking brake.
4. Lower the mower deck(s) if necessary.
5. Shut off the engine and wait for all moving parts to
stop.
6. Turn the ignition key to the S
it.
7. Allow machine components to cool before performing
maintenance.

Removing the Hood

1. Unlatch and raise the hood.
2. Remove the hairpin cotter securing the hood pivot to
the mounting brackets
Figure 33
1. Hairpin cotter
3. Slide the hood to the right side, lift the other side, and
pull it out of the brackets.
Note: Reverse this procedure to install the hood.
position and remove
TOP
(Figure 33).

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that you must lubricate
regularly with No. 2 lithium grease. Also, lubricate the
machine immediately after every washing.
The grease-fitting locations and quantities are:
Traction Unit
•
2 brake pedal pivot-shaft bearings
•
2 front and rear-axle-pivot bushings
•
2 steering-cylinder-ball joints
•
2 tie-rod-ball joints
•
2 king-pin bushings
Note: Lubricate only the top fitting on the king pin
annually (2 pumps).
37
(Figure 34)
(Figure 35)
(Figure 36)
(Figure 36)
(Figure 36).
Figure 34
Figure 35