Led And Tone Interpretation - Sealey VS8801 Manual

NOTE: This function reads off the real time data of
emission-related monitoring systems readiness status. Once the code
reader has finished other operations, for example, clearing trouble
codes, the I/M Readiness Monitor Status program resets status of all
the monitors to "INC" condition. In order to set these monitors to a
Ready status, the vehicle must be driven through a complete drive
cycle. Times for reset vary depending on vehicle. Please refer to
your vehicle's service manual for drive cycle information.
NOTE: In this function, only ENTER/Exit button is available. The
other buttons are disabled to prevent misoperation.

5.3 LED and Tone Interpretation

Select Ready Test from the Main Screen and the screen shows as
below, including applicable monitors status, MIL state, Ignition type,
DTCs (stored one and pending one).
If the code reader is idle, it will show the result immediately. If it is busy,
it will wait till the current procedure is finished. After viewing the status,
press ENTER/Exit button to exit.
"OK"
has completed its diagnostic testing.
"INC"
has not completed its diagnostic testing.
Figure 5.2
-- Indicates that a particular monitor being checked
-- Indicates that a particular monitor being checked
44