NEC Express5800/R320a-E4 User Manual page 76

3-10 Linux Setup and Operation
IMPORTANT:
This must be operated by root user.
Execute the following command. Configure network interfaces eth100100 and
1.
eth110100 that are corresponding to slot 3 as a coupled interfaces.
# vndctl add 3
Execute the command below to configure the network settings (the parts with * are to be
2.
specified by a user) on the combined interface that has been constructed. When you enter
default gateway, you can omit the process by pressing ENTER without specifying
anything.
# vndctl config 3
*Boot Protocol? [none/dhcp/bootp] none
*IP address? 192.168.0.1
*Netmask? 255.255.255.0
*Default gateway (IP)? 192.168.0.1
*Are you sure to set it? [y/n] y
DEVICE=bond2
ONBOOT=yes
BOOTPROTO=none
IPADDR=192.168.0.1
NETMASK=255.255.255.0
GATEWAY=192.168.0.1
Execute the following command to activate the configured coupled-interfaces.
3.
# vndctl up 3
Execute the following command to check the status of the configured coupled-interfaces.
4.
# vndctl status
--Virtual Network Status--
BondingDevice Slot Status InetAddress RXErrors TXErrors Collisions
bond0
bond1
bond2
bond3
bond4
bond5
bond6
bond7
bond8
bond9
Slot
1 top
bottom eth110600 DUPLEX
2 top
1 ONLINE -
2 ONLINE -
3 ONLINE 192.168.0.1
OFFLINE -
OFFLINE -
OFFLINE -
OFFLINE -
OFFLINE -
OFFLINE -
OFFLINE -
RealDevice Status
eth100600 DUPLEX
eth100601 DUPLEX
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
Interface LinkState LinkSpeed
UP LINK
UP LINK
UP LINK
0
0
0
0
0
0
0
0
0
0
1000Mb/s-FD
1000Mb/s-FD
1000Mb/s-FD