G Changing The Paper Size In Paper Tray 1; Changing The Paper Size In Paper Tray 1 - Sharp AR-C260P Operation Manual

Changing the paper size in paper tray 1

The following paper size settings are available for paper tray 1: A3 to A5 (11" x 17" to 8-1/2" x 5-1/2") and "EXTRA"*
Use the following procedure to change the size as needed.
* 1 This is limited to square or rectangular paper that is A3 to A5 (11" x 17" to 8-1/2" x 5-1/2") in size.
Pull out paper tray 1.
1
If paper remains in the tray, remove it.
2 Adjust the paper size slide to the paper
size.
to "EXTRA" and then set the specific paper size as
explained in "Specifying the size when the paper
size is set to "Extra" (except for the bypass tray)"
(page 2-13). (Be sure to set the specific paper
size; if you do not specify what the "extra" size is,
part or all of the image may not print.)
3 Adjust the guide plates A and B by
squeezing their lock levers and sliding
them to the appropriate paper size.
NOTE
If the size slide (step 2 on this page) is not set to the correct paper size, or if the paper type (page 2-12) is not set
correctly, incorrect paper selection or paper misfeeding may occur.
Move the paper size
slide right or left to the
appropriate paper size.
If a size of paper other
than A3 to A5 (11" x 17"
to 8-1/2" x 5-1/2") is
loaded, set the size slide
Load paper in the tray.
4
Gently push tray 1 into the machine.
5
6 Set the paper type.
If you loaded a different type of paper than the
previous paper, be sure to set the new paper type
as explained in "Setting the paper type" (page
2-12).
This completes
7
changing the paper size setting of paper
tray 1.
LOADING PAPER
1
.
Push the tray firmly all
the way into the
machine.
the procedure for
2-3
2