G Setting The Paper Type And Paper Size In The Bypass Tray; Setting The Paper Type And Paper Size In The Bypass Tray - Sharp AR-C260P Operation Manual

Setting the paper type and paper size in the bypass tray

Follow the steps below to set the type and size of the paper loaded in the bypass tray.
Load the paper in the bypass tray before performing these steps.
Press the [MENU] key repeatedly until
1
"BYPASS TRAY PAPER SELECTION"
appears in the message display.
Press the [OK] key.
2
3 Press the [ ] key.
BYPASS TRAY PAPER
SELECTION OK?
4 Press the [OK] key.
If paper has not been loaded in the bypass tray,
"ADD PAPER ONTO BYPASS-TRAY" will appear
then load the paper and press the [OK] key again.
5 Select the appropriate paper type.
The paper type selections are as follows:
"PLAIN", "HEAVY1",
"TRANSPARENCY S", "TRANSPARENCY Q",
"ENVELOPE"
G If heavy paper is loaded, select [HEAVY1] or
[HEAVY2]. For the types of heavy paper that can
be used, see page 2-10.
G If
transparency
[TRANSPARENCY S] or [TRANSPARENCY Q].
[TRANSPARENCY S] is for fast printing, while
[TRANSPARENCY Q] is for a high quality image.
The current paper size
and type settings are
displayed. (If the current
settings are correct,
press the [BACK/C] key
to exit.)
The message at left will
appear.
Press the or key
repeatedly until the
appropriate paper type
appears.
"HEAVY2",
film is loaded, select
The steps that follow differ depending on
6
the paper type selected the step 5. Follow
the steps for the selected type.
G If you selected [PLAIN], [HEAVY1] or [HEAVY2], go to
step 7 to 12.
G If
you selected
[TRANSPARENCY Q], go to step 13.
G If you selected [ENVELOPE], go to step 14 to 15.
7 Press the [OK] key.
AUTO SIZE DETECTION
ENABLE
SIZE DETECTION ENABLE" appears and then
press the [OK] key. This completes the setting.
If you loaded a non-standard size of paper go to
step 8. (next step)
8 Press the or
DETECTION DISABLE" appears.
AUTO SIZE DETECTION
DISABLE
9 Press the [OK] key.
You will now set the X dimension and then the Y
dimension of the loaded paper.
Press (or hold down) the
10
the X dimension and then press the [OK]
key.
PAPER SIZE SETTING
X:139mm
the number is the currently set dimension (for
example, 139 ).
The permitted range for the X dimension is 139 to
432 mm (5-1/2 to 17 inches).
11 Press (or hold down) the
set the Y dimension.
PAPER SIZE SETTING
Y:100mm
the number is the currently set dimension (for
example, 100 ).
The permitted range for the Y dimension is 100 to
297 mm (4 to 11-3/4 inches).
LOADING PAPER
[TRANSPARENCY S]
If you loaded
standard size of paper,
make sure that "AUTO
key until "AUTO SIZE
or key to set
An asterisk "
appearing next to a
number indicates that
or key to
An asterisk "
appearing next to a
number indicates that
2-15
or
2
a
"
"