If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Premaintenance
Procedures
Service Interval Chart
Lubrication
Greasing the Bearings and
Bushings
The machine has grease fittings that must be
lubricated regularly with No. 2 General Purpose
Lithium Base Grease. If the machine is operated
under normal conditions, lubricate all bearings
and bushings after every 50 hours of operation or
immediately after every washing.
The grease fitting locations and quantities are:
Traction Unit
• Brake shaft pivot bearings (5) (Figure 33)
Figure 32
• Traction pedal pivot bushing (1) (Figure 34)
• Front and rear axle pivot bushings (2)
(Figure 35)
• Steering cylinder ball joints (2) (Figure 36)
• Tie rod ball joints (2) (Figure 36)
• King pin bushings (2) (Figure 36).
The top fitting on the king pin should only
be lubricated annually (2 pumps).
34