Table of Contents
Advertisement
Figure 82
1. Adjustment screw
Pivoting (Tilting) the Front
Cutting Unit Upright
Note: Although not needed for normal
maintenance procedures, the front cutting unit
can be pivoted (tilted) to an upright position
(Figure 83). Should you desire to tilt the cutting
unit, proceed as follows:
Figure 83
1. Raise the front cutting unit slightly off of
the floor, set the parking brake, and stop the
engine. Remove the ignition key.
2. Remove the hairpin cotter and clevis pin
securing the deck transport latch to the latch
plate (Figure 84). Pivot latch toward rear of
deck.
2. Deck latch
Figure 84
1. Transport latch
3. Remove the hairpin cotter and clevis pin
securing the height-of-cut chains to the rear of
the cutting unit.
4. Start the engine, slowly raise the front cutting
unit, and stop the engine. Remove the ignition
key.
5. Grasp the front of the cutting unit and lift it
to an upright position.
6. Hold the cutting unit upright, fit the cable end
over the pin on the cutting unit lift arm and
secure it with the hairpin cotter (Figure 85).
Figure 85
1. Cable
Pivoting the Front Cutting
Unit Down
1. With the help of another person, hold the
cutting unit upright, remove the hairpin cotter
securing the cable end, and remove the cable
from the pin.
52
2. Latch plate
2. Pin
Advertisement
Table of Contents
