Operation; Before The First Usage; Filling With Ground Coffee - Silvercrest KH 1081 Operating Instructions Manual

• Remove all packaging materials from the appliance.
• Place the appliance on a dry, flat and heat-resistant
surface.
• Place the glass jug on the heating plate in the
appliance.
• Open the filter holder 8.
• Place the filter insert 2 in such that the coffee
exit 9 projects through the opening.
• Place the permanent filter 1 into the filter insert 2.
• Close the filter holder 8.
• Finally, insert the plug into the power socket.

Operation

Before the first usage

Attention!
• Never fill the water tank with a total volume of
more than 12 cups of mains water.
NEVER fill the water tank with less than 3 cups
of water. Otherwise, the coffee machine could
be damaged. Use the markings on the water-fill
indicator 5.
• Unplug the coffee machine immediately after use.
The appliance is completely free of electrical
power ONLY when it is unplugged.
• Fill the water tank only with mains water.
Using anything else could damage the appliance.
1. Open the glass jug and the water tank lid 4.
2. Carefully rinse the glass jug with mains water.
Fill the water tank with mains water. Pay heed to
pouring the water slowly into the water tank, so
that it can run through both tank openings.
Empty it again by carefully tipping the appliance
over a sink and allowing the mains water to pour
out.
3. Fill the glass jug with 12 cups of mains water.
4. Pour the water completely into the water tank.
5. Close the water tank.
6. Place the emptied glass jug on the heating plate.
7. Switch the coffee machine on with the On/Off
switch 6 (I). The integrated control lamp glows.
Wait until the brewing process is complete.
8. Empty the glass jug.
9. Switch the coffee machine off with the On/Off
switch 6 (O). The integrated control lamp goes
out.
10. Wait until the appliance has cooled down then
rinse the permanent filter 1.
Subsequently, you can use the coffee machine for
the brewing of ground coffee.

Filling with ground coffee

1. Swing the filter holder 8 to the side. Both the
filter insert 2 and the permanent filter 1 must
be inserted.
2. Using the measuring spoon 7 insert coffee powder
(coarse to medium ground) into the permanent
filter 1.
Note:
Use approx. a heaped spoonful of ground coffee per
cup. Should you prefer a weaker coffee, reduce
the amount of ground coffee being used.
Note:
Should you use a too finely ground coffee powder
it could block the permanent filter 1, water can no
longer flow through it and the coffee maker could
overflow!
3. Close the filter holder 8, whilst ensuring that
the coffee exit 9 is located in the middle of
the glass jug.
- 4 -