Operation; Filling The Water Tank; Heating After A Long Time Of Inactivity / During First Use - Silvercrest SEM 1100 D3 Operating Instructions Manual

4) Place the sieve holder i in the appliance by inserting the "INSERT" mark,
which is located next to the hot water shower r, into the appliance and then
turning it clockwise until the handle of the sieve holder i is facing the front
("I" mark) .
5) Insert the plug into a mains power socket .
6) Proceed as follows before the first use, so as to clean the internal pipelines:
Allow sufficient water for about 5 cups of espresso (about 100 ml) to flow
through the appliance . Refer to the section "Operation" .
7) Let the appliance generate steam for about 30 seconds . Refer to the section

"Operation" .

NOTE
► When using the appliance for the first time, it is possible that you can hear
the pump working, even though no water comes out of the appliance . If this
is the case, turn the steam control 7 in the direction of the " ", so that the
air can escape from the pipes of the appliance (the "Steam" button
is pressed) . After approx . 20 seconds the air will have escaped, the noises
disappear and water flows from the appliance .
Operation

Filling the water tank

NOTE
► Use only fresh drinking water for making espresso/cappuccino .
1) Remove the water tank 9 and fill it with water:
Fill it with water to at least the Min marking .
Never fill it past the Max marking .
2) Replace the water tank 9 in the machine .

Heating after a long time of inactivity / during first use

If you have not used it for some time, preheat the appliance as follows:
1) Fill the water tank 9 with tap water .
2) Place either the large o or the small espresso sieve p in the sieve holder i:
–
Make sure that the small indentation on the large o or small espresso
sieve p is located above the indentation on the sieve holder i when
inserted (fig . 1) .
SEM 1100 D3 GB │ IE │ NI │ CY │
4
9 ■