Echolink Memory - Kenwood TH-D74A User Manual

5 Enter a DTMF code for the channel.
When a space is entered, it becomes a "Pause" code.
6 Press [ENT].
DTMF memory channel is stored.
• If you want to store another DTMF memory channel,
repeat the procedure from step 2.
Transmitting Stored DTMF Codes
1 Press and hold [PTT].
2 While transmitting, press [ENT].
• The last called DTMF Memory channel number and
name appears on the display. If no name has been
saved for the channel, the DTMF code appears.
3 While still transmitting, press [
control to select your desired DTMF Memory channel,
then press [ENT] to transmit DTMF code.
• Additionally, you can press a DTMF key corresponding
to your desired channel ([0] ~ [9]) to select the channel
and begin transmission.
• The stored DTMF code scrolls across the display and is
transmitted.
• The code will be transmitted even if you release [PTT]
before the entire code has scrolled across the display.
• If no DTMF code is stored in the selected channel, the
frequency display is restored.
DTMF Key Lock
This function will lock the DTMF transmission keys so that
they will not transmit if they are accidentally pressed while
transmitting. To lock the DTMF keys, turn this function On.
1 Access Menu No. 961.
2 Set the key lock to [On] or [Off].
]/[ ] or rotate the [ENC]

EchoLink MEMORY

EchoLink allows you to communicate with other amateur
radio stations over the internet, using VoIP (voice-over-
IP) technology. The EchoLink software program allows
worldwide connections to be made between stations, or from
computer to station, greatly enhancing your communications
capabilities.
Official EchoLink Website: http://www.echolink.org
Note:
◆ EchoLink memory channels do not store operating frequencies,
tones, or power information.
Storing EchoLink Memory
There are 10 dedicated EchoLink DMTF memory channels
available apart from the normal DTMF memory channels.
You can register Callsigns, node numbers, and control
commands. [Connect by call] and [Query by call] used in
EchoLink are also available through simple operations by
using the Callsign/DTMF auto conversion function.
Note:
◆ EchoLink is a registered trademark of Synergenics, LLC.
1 Access Menu No. 164.
2 Select EchoLink memory channel from 0 ~ 9.
3 Press [A/B].
• The name entry display appears.
4 Enter the name for the channel.
• The Callsign and conference name (for board rooms
that can do round QSO) of the other station which is
connected via EchoLink, or the control command name,
etc., are entered into the EchoLink memory name.
5 Press [ENT].
• The code entry display appears.
6 Enter a DTMF code for the channel.
• The node number of the other station and conference
which are connected via EchoLink, or the DTMF code
of the control command, etc., are entered into the
EchoLink code.
11-2