Preparation; Supplied Accessories; Installing The Antenna; Installing The Battery Pack - Kenwood TH-D74A User Manual

3 PREPARATION

SUPPLIED ACCESSORIES

After carefully unpacking the transceiver, identify the items
listed in the table below. We recommend you keep the box
and packaging for shipping.
Item Comments
Antenna
KNB-75L:
Li-ion battery pack
1800 mAh
Part Number:
Charger
W0H-0033-XX
(AC Voltages:
Part Number:
100 - 240 V, 50/60 Hz)
W0H-0034-XX
for the charger
AC power cable
W0H-0034-XX
Belt clip
Warranty card
English/ French/
Spanish
User Guide
Italian/ German/
Dutch

INSTALLING THE ANTENNA

Hold the supplied antenna by its base, then screw it into the
connector on the top panel of the transceiver until secure.

INSTALLING THE BATTERY PACK

Note:
◆ Because the battery pack is provided uncharged, you must
charge the battery pack before using it with the transceiver.
Match the guides of the battery pack with the corresponding
grooves on the upper rear of the transceiver, then firmly press
the battery case to lock it in place.
To remove the battery pack, lift the release lever to unlock the
battery pack. Lift the battery pack away from the transceiver.
Quantity
TH-D74
A E
1 1
1 1
1 –

INSTALLING ALKALINE BATTERIES

– 1
1 To open the optional KBP-9 battery case lid, press the
– 2 release lever on the top of the battery case, then pull the
cover up.
1 1
c
1 1
1 1
– 1
2 Insert (or remove) six AAA (LR03) Alkaline batteries.
• When removing the Alkaline batteries from the battery
case, pull up on the batteries from the positive (+)
terminal.
• Be sure to match the battery polarities with those
marked in the bottom of the battery case.
3 Align the two tabs at the bottom of battery case, then
close the cover until the locking tabs on top click.
4 To install the battery case onto (or remove it from) the
transceiver, follow "INSTALLING THE BATTERY PACK".
Note:
◆ Do not use Manganese batteries or Rechargeable batteries in
place of Alkaline batteries.
◆ Remove all batteries from the case when it is not expected to
be in use for several months.
◆ To lift the battery pack safety catch, use a piece of hardened
plastic or metal, such as a screwdriver, that is no more than
6 mm wide and 1 mm thick. It is imperative that you place the
implement under only the lip of the safety catch so that you do
not damage the release latch.
3-1
a
b