Installation Procedure - Toshiba RAS-13BKV-E Service Manual

10-1. Installation Diagram of Indoor and Outdoor Units
Batteries
3
2
Wireless remote control
• Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (-) positions.

10. INSTALLATION PROCEDURE

6
Flat head
4
Remote control holder
wood screw
Vinyl tape
Apply after carrying
out a drainage test.
Before installing the wireless remote controller
2 Wireless remote controller
Hook
Installation
1
plate
Shield pipe
Saddle
Extension drain hose
(Not available, provided
by installer)
- 47 -
FILE NO. SVM-16003
For the rear left and left piping
Wall
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
Do not allow the drain hose to get slack.
Cut the piping
hole sloped
slightly.
Make sure to run the drain hose sloped
downward.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear
right
Left
Bottom Rear
right left
Bottom left
Insulate the refrigerant pipes separately
with insulation, not together.
6 mm thick heat resisting
polyethylene foam
3 Batteries