Toshiba RAS-13BKV-E Service Manual page 51

10-3. Indoor Unit
10-3-1. Installation place
• A place which provides the spaces around the indoor
unit as shown in the diagram
• A place where there are no obstacles near the air inlet
and outlet
• A place which allows easy installation of the piping to the
outdoor unit
• A place which allows the front panel to be opened
The indoor unit shall be installed at least 2.0 m height. Also,
•
it must avoided to put anything on the top of the indoor unit.
CAUTION
• Direct sunlight to the indoor unit's wireless
receiver should be avoided.
• The microprocessor in the indoor unit should not
be too close to RF noise sources.
(For details, see the owner's manual.)
<Remote control>
• A place where there are no obstacles such as a
curtain that may block the signal from the indoor
unit.
• Do not install the remote control in a place exposed
to direct sunlight or close to a heating source, such
as a stove.
• Keep the remote control at least 1 m apart from the
nearest TV set or stereo equipment. (This is
necessary to prevent image disturbances or noise
interference.)
• The location of the remote control should be
determined as shown below.
(Side view)
Remote
Reception
control
range
(Top view)
Indoor unit
Reception
range
Fig. 10-3-1
10-3-2. Cutting a hole and mounting installation
<Cutting a hole>
When installing the refrigerant pipes from the rear.
1. After determining the pipe hole position on the
mounting plate (A), drill the pipe hole (∅ 65 mm) at
a slight downward slant to the outdoor side.
NOTE
• When drilling a wall that contains a metal lath, wire
lath or metal plate, be sure to use a pipe hole brim
ring sold separately.
<Mounting the installation plate>
Pipe hole
Remote
control
- 51 -
FILE NO. SVM-16003
The center of the pipe hole
is above the arrow.
Fig. 10-3-2
Hook
Hook
Thread
Indoor unit
Weight
Fig. 10-3-3
Pipe hole
Ø65 mm
120 mm
65
103
1
Installation
Hook
plate
Pipe hole
5 Mounting screw