Siemens Gigaset A580 IP User Manual page 154

You cannot hear a ringer/dialling tone from the fixed line network.
The phone cord supplied has not been used or has been replaced by a new cord with the
wrong pin connections.
¥
Please always use the phone cord supplied or ensure that the pin connections are
correct when purchasing from a retailer (
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Re-enter system PIN.
Have you forgotten the system PIN?
¥
Reset the base station to set the system PIN back to 0000 (
The other party cannot hear you.
You have pressed the k key or the
¥
Press the display key to re-activate the microphone (
§On§
When making calls from the fixed line network, the caller's phone number is not
displayed although CLIP (
Calling Line Identification is not enabled.
¥
The caller should ask his network provider to enable Calling Line Identification (CLI).
You hear an error tone when keying an input (a descending tone sequence).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user guide if necessary.
You cannot connect to the router and the phone is assigned a static IP address.
¥
Check on the router whether the IP address is already being used by another device
in the LAN or belongs to the block of IP addresses that is reserved on the router for
dynamic address assignment.
¥
If necessary, change the phone's IP address (
You have made a call via VoIP but cannot hear the other caller.
Your phone is connected to a router with NAT/firewall.
¥
Your STUN server (
incomplete or incorrect. Check the settings.
¥
No outbound proxy is entered or the outbound proxy mode
£
( Page 122) and your phone is connected to a router with symmetric NAT or a
blocking firewall.
¥
Port forwarding is activated on your router, but no permanent IP address has been
assigned to your phone.
You cannot make calls via VoIP.
¥
First wait a few minutes. This is often a short-term event that corrects itself after a
short time.
If the message continues to be displayed, proceed as follows:
¥
Check whether your phone's Ethernet cable is correctly connected to the router.
¥
Check your router's cable connection to the Internet.
¥
Check whether the phone is connected to the LAN. Send a ping command, e.g. from
your PC, to the phone (ping s <local IP address of the phone>). It may be that no IP
address could be assigned to the phone or a permanently set IP address is already
assigned to another LAN subscriber. Check the settings on the router, you may have
to activate the DHCP server.
§Mute§ display key. The handset is "muted".
£
Page 42) is set.
£
Page 121) or outbound proxy (
Server not accessible
Customer Service (Customer Care)
£
Page 163).
£
Page
£
Page
£
Page 98).
£
Page 122) settings are
Never
is displayed.
93).
45).
is activated
153