Configuring Ldk24 System For Managing Ldk24 System Via Usb Cable; Bridged Configurations : Ethernet - Usb Bridged - LG LDK24 ADSL Router User Manual

If the LDK24 System is restarted, the image will be downloaded silently over USB. The
c.
above procedure is only followed the first time that a LDK24 System is booted over
USB.
B.2 Configuring LDK24 system for managing LDK24 system via USB cable
This section describes how to configure the LDK24 System for USB Web admin or internet
LDK24 system provides three types of configurations as below

• Bridged configurations : Ethernet - USB bridged

• Routed configurations : IPoA routed example
• Bridged/Routed configuration : PPPoE routed example
B.2.1 Bridged configurations : Ethernet - USB bridged
For this configuration, you need to attach the Ethernet devices called ethernet and usb-ethernet
to the bridge. If you want to change default LAN IP address, refer to Annex C : Changing default
LAN IP address.
You can set "Bridged configurations" by following instructions.
a. From the left-hand menu, click on Configuration>WAN connections like picture below
Refer to the figure-5
b. The WAN connections page is displayed. If there are any connections listed, click on the
Delete hyperlink, then click on Delete this connection. Repeat until all WAN
connections have been deleted like picture below.
Refer to figure-7
c. From the Status page, click on the LAN Settings hyperlink or from the left-hand menu,
click on Configuration>LAN connection. The LAN connections page is displayed. like
picture below.
LDK24 ADSL Router User's Manual
Version 1.0D
Copyright© 2002 LG Electronics Inc., LTD.
Page 55 of 67