Printer Settings (For Key Operator) - Panasonic DP-180 Network Scanner Operations

Function
■ Printer Settings (Continued)
No.
05 2-SIDED PRINT
06 BIND POSITION
07 RESOLUTION
08 FONT (PCL)*1
SYMBOL TABLE (PCL) *
09
PITCH (PCL) *
10
POINT SIZE (PCL) *
11
LINES/PAGE (PCL) *
12
RETURN CHARACTER (PCL) *
13
14 MUTUAL A4/LETTER
MAILBOX MEMORY *
15
19 KEY OPERATOR MODE
* 1
Available only when the optional Printer Controller Module is installed.
*
2
Available only when the optional Hard Disk Drive Unit is installed.
The following Parameter Settings require the input of the Key Operator Password:

■ Printer Settings (For Key Operator)

No.
00 PRINTER SETTINGS
01 COMPLETION TIME
02 PAGE PROTECTION
40
Modes
Selects whether the 2-Sided print setting is
enabled.
1:OFF / 2:ON
Sets the bind position.
1:LONG EDGE / 2:SHORT EDGE
Sets the resolution setting.
1:300dpi / 2:600dpi / 3:1200dpi
Sets the PCL font.
0-99
1
Sets the PCL symbol table.
0-35
1
Sets the PCL pitch.
0.44-99.99
1
Sets the PCL point size.
4.00-999.75
1
Sets the PCL lines/page.
5-128
1
Sets the PCL return character.
1:CR / 2:CR+LF
Selects whether the mutual size A4/LETTER is
enabled.
1:OFF / 2:ON
2
Indicates the mailbox memory status.
Inputs the key operator password.
ENTER PASSWORD =
Modes
Prints the printer settings.
PRESS SET TO PRINT
Sets the job completion time setting.
1-999SEC (second)
Selects whether to enable automatic
compression when the received data exceeds
the page memory capacity.
(This is accomplished by reducing resolution,
and/or deleting pixels to fit the data onto the
available page memory, then print it out.)
When the setting is in the "OFF" position, upon
exceeding the page memory capacity, the print
job is deleted and an Error message is displayed.
1:OFF / 2:ON
Function
Function
Initial
Setting
1:OFF
1:LONG EDGE
2:600dpi
0
11
10.00
12.00
60
1:CR
1:OFF
Initial
Setting
180SEC
1:OFF
<to be continued>