Configuration Example; Network Requirements; Configuration Procedure - HP MSR4080 Configuration Manual

Configuration example

Network requirements

As shown in
with a source port number other than 21.
Figure 19 Network diagram

Configuration procedure

# Create advanced ACL 3000,
21 .
<Router> system-view
[Router] acl number
[Router-acl-adv-3000] rul
[Router-acl-adv-3000] quit
# Create a traffic class named classifier_1, and use ACL 3000 as the match c
[Router] traffic classifier classifier_1
[Router-classifier-classifier_1] if-match acl 3000
[Router-classifier-classi
# Create a traffic behavior named behavior_1, and configure the traffic filterin
[Router] traffic behavior behavior_1
[Router-behavior-behavi
[Router-behavior-behavio
# Create a QoS policy nam
behavior_1
[Router] qos policy policy
[Router-qospolicy-policy] classifier classifier_1 behavior behavior_1
[Router-qospolicy-po
# Apply the QoS policy
[Router] interface giga
[Router-GigabitEthern
Figure 19, configure traffic filtering on GigabitEthernet 2/1/0 to deny the incoming packets
and configure a rule to match packets whose source port number is not
3000
e 0
fie r_1] quit
or_1]
r_1] quit
ed policy, and associate traffic
in the QoS policy.
licy] quit
named policy to the incoming traffic of Giga
bitethernet 2/1/0
et 2/1/0] qos apply policy policy inbound
permit tcp source-port neq 21
fil ter deny
67
riterion in the traffic c
g action to drop packet
class classifie r_1 with traffic beh
bitEthernet 2/1/0.
lass.
s.
avior