Qppb Configuration Example In An Ipv6 Network - HP MSR4080 Configuration Manual

QPPB configuration example in an IPv6 network

Network requ irements
As sh own in
Conf igure QPPB so that Router B can perform the following tasks:
Receive routes.
•
Set the QPPB IP precedence value.
•
Use the QoS policy to limit the rate of traffic with a specif
•
Figur e 24 Network diagram
Configur ation procedure
1. Configure IPv6 addresses for each interfac
2. Configure BGP on Router A.
<RouterA> system-view
[RouterA] bgp 1000
[RouterA] peer 168::2 as-number 2000
[RouterA] peer 168::2 connect-interface gigabitethernet 2/1/1
[RouterA-bgp] address-family ipv6
[RouterA-bgp-ipv6] peer 168::2 enable
[RouterA-bgp-ipv6] import-route direct
[RouterA-bgp-ipv6] quit
[RouterA-bgp] quit
3. Configure Router B:
# Configure BGP.
<RouterB> system-view
[RouterB] bgp 2000
[RouterB] peer 168::1 as-number 1000
[RouterB] peer 168::1 connect-interface gigabitethernet 2/1/1
[RouterB-bgp] address-family ipv6
[RouterB-bgp-ipv6] peer 168::1 enable
[RouterB-bgp-ipv6] peer 168::1 route-policy qppb import
[RouterB-bgp-ipv6] quit
[RouterB-bgp] quit
# Configure a routing policy.
[RouterB] route-policy qppb permit node 0
[RouterB-route-policy-qppb-0] apply ip-precedence 4
[RouterB-route-policy-qppb-0] quit
Figure 24, all routers run BGP.
ic IP precedence value to 512 kbps.
e. (Details not shown.)
88