Removing The Convection Element, Fan Blade And Fan Motor - LG LSE4613ST Service Manual

REMOVING THE CONVECTION ELEMENT
REMOVING THE CONVECTION ELEMENT
1. Disconnect power and remove oven racks.
2. Pull the range out of its mounting location so that
you can access the rear of the unit.
3. Remove the rear panel from the unit.
(See step 3 on page 3-2 for procedure)
4. Disconnect the wire connection.
5. Remove the four Fan cover screws and set the
fan cover aside.
6. Remove the two convection element screws and
pull the element forward.
COMPONENT ACCESS
, F AN BLADE AND F
, F AN BLADE AND F
7. To remove Fan blade, remove Nut by screwing
clockwise. Fan blade can be replaced from inside
oven.
!
• Be careful not to bend the fan blade
- Failure to do so can result in vibration, noise,
and poor performance of convection when
operating.
8. To remove Fan motor assembly, disconnect
wire connection and remove the three bracket
screws
9. Pull the fan motor assembly forward.
Convection
Fan cover
Fan cover screws (4ea)
3-11
AN MOT
AN MOT
CAUTION
Rear-fan
Fan
blade
blade
heater
Washer
Bushing
Washer
Nut
OR
OR
Fan motor