Ttp14: Point Trouble With D8125Inv And Inovonics Wireless Devices Connected To The Control Panel - Bosch D9412GV2 Troubleshooting Manual

D9412GV2/D7412GV2 | Troubleshooting Guide | 3.0
TTP14: Point Trouble with D8125INV and
Inovonics Wireless Devices
Connected to the Control Panel
Procedure
Are all wireless points "missing"?
Are any wireless points "missing"?
If the D8125INV LCD display and keypad
backlight are both dark, refer to
Device or
on page 111.
On the D8125INV:
1. Enter the passcode, then press [ENT].
2. Enter the number of a wireless point that
is in trouble, then press [ENT].
3. View the transmitter's mode (refer to Item
1 in Figure 26
Table 26
Is the mode correct for the desired
transmitter, or if using an FA210 or FA210W
Receiver, is the mode correct for the
desired operation?
Reprogram the transmitter as a new
transmitter.
Do not reconfigure the transmitter
as an existing transmitter.
You might need to perform this
procedure on more than one
transmitter.
During this service call, was the transmitter
programmed as an existing transmitter?
A B C D
48
TTP51
Module Does Not Have Power
on page 52), then refer to
on page 51.
Troubleshooting
A B C D
On the D8125INV:
1.
2.
3.
4.
5.
6.
Do the values match the conditions of
the wireless transmitter?
Using a keypad connected to the control
panel, view Point Assignments for the
point you are troubleshooting. Determine
which point index the point uses. View
that point index. Determine the Type and
Point Response (for more information,
refer to
29 on page 53).
Is the point programmed to respond as
desired?
View point status for the point you are
troubleshooting. Refer to
page 52. Retest the wireless transmitter.
Does the point show the correct
condition of the wireless transmitter?
A B C E
Bosch Security Systems, Inc. | 11/05 | F01U011024B
Enter the passcode, then press
[ENT].
Press [DIAG].
Press [1].
Enter the number of a wireless point
that is in trouble, then press [ENT].
Test the wireless transmitter.
Refer to Item 2 in Figure 27
52, and refer to Table 27 on page
52.
Move the transmitter to within 10 ft.
of the FA400 Receiver, then retest
the wireless transmitter.
•
If the values still do not match
the conditions of the wireless
transmitter, remove the battery
from the old transmitter, and
install a new transmitter.
•
If the values now match the
conditions of the wireless
transmitter, then either
relocate the transmitter,
relocate the receiver, or add
an FA570 Repeater to the
system.
After reconfiguring a wireless
system, always retest the
system to ensure all devices
operate correctly.
Table 28 on page 52 and
Fix the programming problem.
Table 28
F
on page
Table
on